Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: HVAC & Restraints

READ NEXT:

 Heating, Ventilation, and Air Conditioning

 Diagnostic information and procedures

 Leak testing

SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS Adhesives, Fluids, Lubricants, and Sealers REFRIGERANT SYSTEM SPECIF

SEE MORE:

 Rear differential clutch control module programming and setup

Special Tools EL-49642 SPS Programming Support Tool For equivalent regional tools, refer to Special Tools. NOTE: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the ECU is not properly configured with the correct calibration software, the ECU w

 DTC B3951

Ignition OFF, disconnect the X5 harness connector at the K9 Body Control Module, ignition ON. Verify a test lamp illuminates between the B+ circuit terminal 3 and ground. If the test lamp does not illuminate and the circuit fuse is good Ignition OFF. Test for less than 2 ohms in the B+

© 2019-2025 Copyright www.chevtrax.com