Chevrolet Trax: Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / HVAC & Restraints / Heating, Ventilation, and Air Conditioning / Repair instructions
- Odor correction
- Air conditioning compressor oil balancing
- Air conditioning compressor replacement (2H0)
- Air conditioning clutch assembly replacement (LUJ, LUV)
- Air conditioning system seal replacement
- Air conditioning compressor hose replacement (LUJ, LUV)
- Air conditioning condenser hose replacement (2H0)
- Air conditioning evaporator hose assembly replacement (LUJ, LUV)
- Air conditioning (a/c) refrigerant pressure sensor replacement (LUJ, LUV)
- Heater and air conditioning evaporator and blower module removal and installation
- Heater and air conditioning evaporator and blower upper case replacement
- Heater outlet hose replacement (LUJ, LUV REAR)
- Air inlet assembly replacement
- Air distributor case replacement
- Floor rear air outlet duct replacement - left side
READ NEXT:
Odor correction
Eliminating Air Conditioning Odor
Odors may be emitted from the air conditioning system primarily at start
up in hot, humid climates. The
following conditions may cause the odor:
Debris is pre
Air conditioning compressor oil balancing
Draining Procedure
NOTE: Drain and measure as much of the refrigerant oil as possible
from the rear
head ports of the removed air conditioning compressor.
Before draining oil, position the compress
Air conditioning compressor replacement (2H0)
Fig. 4: Air Conditioning Compressor (2H0)
Air Conditioning Compressor Replacement (2H0)
COMPRESSOR LEAK TESTING (R-134A)
Special Tools
GE-39400-A Halogen Leak Detector
GE-41447 R-134A A/C Tra
SEE MORE:
DTC B3882
Ignition OFF, exterior lamps OFF, trunk latch latched, remove the E5AB
Tail/Stop Lamp - Right bulb.
Test for less than 5 ohms between the ground circuit at the socket
terminal and ground.
If 5 ohms or greater
Ignition OFF.
Test for less than 2 ohms in the ground circuit end to end.
DTC B3949
Ignition OFF, disconnect the X2 harness connector at the K9 Body Control
Module, ignition ON.
Verify a test lamp illuminates between the B+ circuit terminal 3 and
ground.
If the test lamp does not illuminate and the circuit fuse is good
Ignition OFF.
Test for less than 2 ohms in the B+
© 2019-2025 Copyright www.chevtrax.com
