Chevrolet Trax: Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Suspension & Steering / Power Steering / Repair instructions
- Steering linkage inner tie rod inspection
- Power steering system bleeding
- Power steering pump replacement
- Power steering pump bracket replacement
- Power steering fluid reservoir outlet hose replacement
- Power steering gear inlet pipe/hose replacement
- Power steering gear outlet pipe/hose replacement
- Steering gear replacement (N40)
- Steering gear replacement (NJ1)
READ NEXT:
Steering linkage inner tie rod inspection
Special Tools
GE-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
NOTE: This inspection procedure does not supersede local government
required
inspections that have more
Power steering system bleeding
NOTE:
Use clean, new power steering fluid only. Refer to Adhesives, Fluids,
Lubricants, and Sealers.
Hoses touching the frame, body or engine may cause system noise.
Ensure the hoses do not touc
Power steering pump replacement
Removal Procedure
Place drain pans under the vehicle.
Remove as much power steering fluid from the power steering fluid
reservoir as possible.
Remove the air cleaner assembly.
Remove the power
SEE MORE:
Heated steering wheel malfunction
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
Diagnostic Fault
Spark plug inspection
Spark Plug Usage
Ensure that the correct spark plug is installed. An incorrect spark plug
causes driveability conditions.
Refer to the Electronic Parts Catalog.
Ensure that the spark plug has the correct heat range. An
incorrect heat range causes the following
conditions:
Spark pl
© 2019-2026 Copyright www.chevtrax.com
