Chevrolet Trax: Repair instructions - on vehicle
Chevrolet Trax (2013-2022) Workshop Manual / Transmission / Automatic Transmission - 6T40 (MH8 MHB) / Repair instructions - on vehicle
- Manual shift detent lever with shaft position witch assembly replacement
- Automatic transmission range selector lever replacement
- Range selector lever cable adjustment
- Transmission fluid drain and fill
- Manual shift shaft and seal replacement
- Control valve body cover replacement
- Transmission mount bracket replacement -REAR (AWD)
- Transmission mount replacement - left side
- Transmission replacement
READ NEXT:
Manual shift detent lever with shaft position witch assembly replacement
Special Tools
DT-41229 Manual Shaft Pin Installer
For equivalent regional tools, refer to Special Tools .
Removal Procedure
Remove the engine coolant fan shroud. Refer to Engine Coolant Fan Shroud
Automatic transmission range selector lever replacement
Removal Procedure
Set the park brake and chock the wheels.
Fig. 4: Automatic Transmission Range Selector Lever Cable Terminal And Shift
Lever Pin
Disconnect the transmission range selector lev
Range selector lever cable adjustment
NOTE: Adjust the automatic transmission range selector cable while
the
transmission and the gear selector are in the Park position only. Failure to
do so may cause mis-adjustment.
Set the park brak
SEE MORE:
Engine Coolant
The cooling system in the vehicle is
filled with DEX-COOL engine
coolant. This coolant is designed to
remain in the vehicle for 5 years or
240 000 km (150,000 mi), whichever
occurs first.
The following explains the cooling
system and how to check and add
coolant when it is low. If there is a
proble
Fuel system diagnosis (LUJ)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
Circuit/System De
© 2019-2026 Copyright www.chevtrax.com
