Chevrolet Trax: Repair instructions
- Front disc brake pads replacement
- Rear disc brake pads replacement
- Brake pad and rotor burnishing
- Rear brake caliper replacement
- Front brake caliper overhaul
- Front brake caliper bracket replacement
- Rear brake caliper bracket replacement
- Front brake rotor replacement
- Rear brake rotor replacement
- Front brake shield replacement
- Brake rotor assembled lateral runout correction
- Brake rotor assembled lateral runout correction - on vehicle lathe
READ NEXT:
Front disc brake pads replacement
Removal Procedure
WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
NOTE: Always replace disc brake pads in axle sets.
Inspect the fluid level in the brake mast
Rear disc brake pads replacement
Removal Procedure
WARNING: Refer to Brake Dust Warning .
Inspect the fluid level in the brake master cylinder reservoir.
If the brake fluid level is midway between the maximum-full point and
the
Brake pad and rotor burnishing
WARNING: Road test a vehicle under safe conditions and while obeying
all traffic laws. Do not attempt any maneuvers that could
jeopardize vehicle control.
Failure to adhere to these precautions cou
SEE MORE:
DTC B0017 OR B0024: Knee air bag deployment loop
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
Data communications - Description and operation
BODY CONTROL SYSTEM DESCRIPTION AND OPERATION
The body control system consists of the body control module (BCM),
communications, and various input and
outputs. Some inputs, outputs and messages require other modules to interact
with the BCM. The BCM also has
discrete input and output terminals to
© 2019-2026 Copyright www.chevtrax.com
