Chevrolet Trax: Repair instructions - on vehicle
Chevrolet Trax (2013-2022) Workshop Manual / Transmission / Manual Transmission - M20 M32 (MR5) / Repair instructions - on vehicle
- Transmission fluid drain and fill
- Selector and shift lever cable bracket replacement
- Backup lamp switch replacement
- Transmission mount bracket replacement - Rear (FWD)
- Front wheel drive shaft seal replacement - right side (FWD)
READ NEXT:
Transmission fluid drain and fill
Draining Procedure
NOTE:
The fluid check bolt at the front of the transmission may not be
opened.
The transmission fluid drained out during the pre-delivery inspection
may
be re-used. New tra
Selector and shift lever cable bracket replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement .
Fig. 28: Shift Lever And Selector Lever Cable End
Disconnect the shift lever and selector lever cable end (1) from
Backup lamp switch replacement
Fig. 42: Backup Lamp Switch
Backup Lamp Switch Replacement
TRANSMISSION REAR MOUNT REPLACEMENT (AWD)
Removal Procedure
Remove the transfer case. Refer to Transfer Case Replacement .
Fig. 43:
SEE MORE:
DTC U0074: Control module communication bus B OFF
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Heater and air conditioning evaporator and blower module removal and
installation
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and
Connection .
Recover the refrigerant system. Refer to Refrigerant Recovery and
Recharging (R-134a).
Drain the engine coolant system. Refer to Cooling System Draining
and Filling .
R
© 2019-2026 Copyright www.chevtrax.com
