Chevrolet Trax: Repair instructions
- Antilock brake system automated bleed
- Steering angle sensor replacement
- Brake pressure modulator valve replacement
- Brake pressure modulator valve bracket replacement
- Rear wheel speed sensor replacement
- Vehicle stability control system switch replacement
READ NEXT:
Antilock brake system automated bleed
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution .
NOTE: Before performing the Antilock Brake System (ABS) Automated
Steering angle sensor replacement
Fig. 7: View Of Steering Angle Sensor
Steering Angle Sensor Replacement
STEERING ANGLE SENSOR CENTERING
The steering angle sensor does not require centering often. Centering of the
steering angle
Brake pressure modulator valve replacement
Removal Procedure
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution .
CAUTION: Always connect or disconnect the wiring
SEE MORE:
DTC B0017 OR B0024: Knee air bag deployment loop
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
Horns - Description and operation
HORNS SYSTEM DESCRIPTION AND OPERATION
System Description
The horn system consists of the following components:
HORN fuse
Underhood fuse block (contains PCB horn relay)
Horn switch
Horn-low note
Horn-high note
Body control module (BCM)
14 Horns Block Diagram
Fig. 6: 14 Horns Block Diagram
© 2019-2026 Copyright www.chevtrax.com
