Chevrolet Trax: Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Suspension & Steering / Front Suspension / Repair instructions
- Stabilizer shaft replacement
- Front wheel bearing and hub replacement
- Steering knuckle replacement
- Wheel stud replacement
- Strut assembly removal and installation
- Strut, strut component, or spring replacement
READ NEXT:
Stabilizer shaft replacement
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
STABILIZER SHAFT REPLACEMENT
Removal Procedure
Remove the intermediate steering shaft upper
Front wheel bearing and hub replacement
Special Tools
CH-50559 Wheel Hub/Bearing Remover Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
Steering knuckle replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation .
Disconnect th
SEE MORE:
DTC B1265: Switched 14 volt performance short to ground
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptor
DT
Bluetooth malfunction (radio - with UH7)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provide an overview of each diagnostic
category.
Circuit/System Des
© 2019-2026 Copyright www.chevtrax.com
