Chevrolet Trax: DTC C0475: Electric steering motor
Diagnostic Instructions
- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC C0475 00
Electric Steering Motor Circuit Malfunction
DTC C0475 64
Electric Steering Motor Slip Detected
Circuit/System Description
The power steering control module continuously monitors the voltage and current levels being commanded to the 3-phase steering assist motor. The power steering control module compares the desired and actual current levels to detect malfunctions in the internal power steering assist motor circuits.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
The power steering control module detects a short to ground, short to voltage, or an open/high resistance on any of the internal power steering assist motor circuits.
Action Taken When the DTC Sets
- The DTC is stored in memory.
- No steering assist.
Conditions for Clearing the DTC
A history DTC will clear after 40 consecutive malfunction free ignition cycles.
Reference Information
Schematic Reference
Power Steering Schematics (Encore), Power Steering Schematics (Trax)
Connector End View Reference
WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INDEX - ENCORE WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INDEX - TRAX
Description and Operation
Power Steering System Description and Operation
Electrical Information Reference
- Circuit Testing
- Connector Repairs
- Testing for Intermittent Conditions and Poor Connections
- Wiring Repairs
Scan Tool Reference
Control Module References for scan tool information.
Circuit/System Testing
- Verify that DTC C0475 is not set.
- If the DTC is set
Replace the K43 Power Steering Control Module.
- If the DTC is not set
- All OK.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the repair.
- Steering Column Replacement (Mexico, N40) , Steering Column Replacement (Canada, NJ1) , Steering Column Replacement (United States, NJ1)
- Control Module References for power steering control module replacement, programming and setup.
READ NEXT:
DTC C0545: Steering wheel torque sensor
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC C056D: Electronic control unit hardware
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
Power steering system test
Special Tools
CH-44721 Power Steering Analyzer
For equivalent regional tools, refer to Special Tools.
Rack and Pinion System
Fig. 3: Testing Rack and Pinion System Pressures
Test Description
The
SEE MORE:
Power brake booster pump bracket replacement
Removal Procedure
Remove the power brake booster pump assembly. Refer to Power Brake
Booster Pump Replacement.
Fig. 187: Power Brake Booster Pump
Disconnect the power brake booster pump vent hose (1).
Release the power brake booster pump electrical harness and retainer
from the power bra
Brake, accelerator, and clutch pedal replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement .
Fig. 29: Power Vacuum Brake Booster Bolts
Remove the power vacuum brake booster bolts (1).
Fig. 30: Brake Pedal Assembly Upper Nuts
Remove the brake pedal assembly upper nuts (1)
Fig. 31: Brake Pedal Assemb
