Chevrolet Trax: Diagnostic information and procedures
Chevrolet Trax (2013-2022) Workshop Manual / Brakes / Antilock Brake System / Diagnostic information and procedures
- DTC B2745 (WITH C67/CJ2): Traction control switch
- DTC B2745 (WITH C60/C41): Traction control switch
- DTC C0035, C0040, C0045, OR C0050: Wheel speed sensor
- DTC C0110: Pump motor
- DTC C0131: Traction control system pressure circuit
- DTC C0161: Antilock brake system brake switch
- DTC C0186, C0196, OR C0287: Lateral acceleration sensor/yaw rate sensor/lateral acceleration sensor
- DTC C0201: Antilock braking system enable relay primary ircuit
- DTC C0242 OR P0856: Traction control malfunction/traction control orque request signal
- DTC C0277: Brake pedal position sensor circuit calibration not learned
- DTC C027C: Front brake discs high temperature
- DTC C0292: Multi-axis acceleration sensor module circuit performance - bias level out of range
- DTC C0551: Multi-axis acceleration sensor module circuit erformance - bias level out of rangee
- DTC C0561: System disabled information
- DTC C0710: Steering position signal calibration
- DTC C1207, C1208, C1221, C1222, C1225, C1226, C1232, OR C1233: Front wheel speed sensor
- DTC C124F OR C1250-C1254: Lateral acceleration sensor/longitudinal acceleration sensor
- DTC C1589: Multi-axis acceleration sensor/steering wheel angle sensor supply voltage circuit performance - bias level out of range
- Symptoms - antilock brake system
- Traction control/stability control indicator malfunction (WITH C67/CJ2)
- Traction control/stability control indicator alfunction
READ NEXT:
DTC B2745 (WITH C67/CJ2): Traction control switch
DIAGNOSTIC CODE INDEX
DTC B2745 (WITH C67/CJ2): Traction control switch
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Revie
DTC B2745 (WITH C60/C41): Traction control switch
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC C0035, C0040, C0045, OR C0050: Wheel speed sensor
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Cleanliness and care
An automobile engine is a combination of many of the following surfaces:
Machined
Honed
Polished
Lapped
The tolerances of these surfaces are measured in the ten-thousandths of an
inch. When you service any internal
engine part, cleanliness and care are important. Apply a liberal coating of
e
Camshaft intake and exhaust sprocket replacement
Special Tools
EN-955-A Locking Pin
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the air cleaner assembly. Refer to Air Cleaner Assembly
Replacement .
Remove the camshaft cover. Refer to Camshaft Cover Replacement.
Remove both camshaft position actuator soleno
© 2019-2026 Copyright www.chevtrax.com
