Chevrolet Trax: Collision repair - Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Collision Repair / Collision repair - Repair instructions
- Front wheelhouse panel replacement
- Front compartment upper side rail replacement
- Front compartment side rail replacement
- Front compartment side rail sectioning
- Front hinge pillar body sectioning
- Body hinge pillar lower reinforcement replacement
- Roof outer panel replacement
- Roof front header panel replacement
- Roof rear header panel replacement
- Rocker inner panel replacement
- Rocker outer panel sectioning
- Body side frame rocker reinforcement replacement
- Front side door outer panel replacement
- Rear side door outer panel replacement
- Rear compartment floor panel replacement
- Rear wheelhouse outer panel replacement
- Quarter outer panel sectioning
- Center pillar inner panel replacement
- Center pillar reinforcement replacement
- Center pillar sectioning - outer
- Rear rail sectioning
- Rear end panel replacement
- Body tail lamp filler panel replacement
READ NEXT:
Front wheelhouse panel replacement
Removal Procedure
Disable the SIR system. Refer to SIR Disabling and Enabling .
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and
Connection
NOTE: Section
Front compartment upper side rail replacement
Removal Procedure
WARNING: Refer to Approved Equipment for Collision Repair Warning .
Disable the SIR system. Refer to SIR Disabling and Enabling .
Disconnect the negative battery cable. Refer to B
Front compartment side rail replacement
Removal Procedure
WARNING: Refer to Approved Equipment for Collision Repair Warning .
WARNING: Refer to Glass and Sheet Metal Handling Warning .
Disable the SIR System. Refer to SIR Disabling and En
SEE MORE:
DTC U0255-U0257: Lost communication with info display
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
Cleanliness and care
An automobile engine is a combination of many of the following surfaces:
Machined
Honed
Polished
Lapped
The tolerances of these surfaces are measured in the ten-thousandths of an
inch. When you service any internal
engine part, cleanliness and care are important. Apply a liberal coating of
e
© 2019-2026 Copyright www.chevtrax.com
