Chevrolet Trax: Vehicle Diagnostic Information - Diagnostic Information and Procedures
Chevrolet Trax (2013-2022) Workshop Manual / General Information & Maintenance / Vehicle Diagnostic Information - Diagnostic Information and Procedures
- Diagnostic Information and Procedures
- Diagnostic system check instructions
- Diagnostic system check - vehicle
- Powertrain diagnostic trouble code (dtc) type definitions (luv)
- Diagnostic trouble code (DTC) list - vehicle
- Symptoms - vehicle
- Specifications
- Communication interface module scan tool information
- Power steering control module scan tool information
READ NEXT:
Diagnostic Information and Procedures
STRATEGY BASED DIAGNOSIS
The goal of Strategy Based Diagnosis is to provide guidance when you create a
plan of action for each specific
diagnostic situation. Following a similar plan for each diagnos
Diagnostic system check instructions
The following is an overview of instructions for the general information and
13 step System Verification
included in the Diagnostic System Check - Vehicle procedure.
Diagnostic Instructions
A link to
Diagnostic system check - vehicle
Diagnostic Instructions
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic System Check Instructions provides an overview of each
diagnostic step.
Continue
SEE MORE:
Clutch actuator cylinder front pipe replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement .
Fig. 15: Clutch Actuator Cylinder Front Pipe
Unclip the clutch actuator cylinder front pipe from the 2 retainers (1).
Fig. 16: BPMV Bracket Assembly
Remove the clutch actuator cylinder pipe retainer (1).
Remo
DTC B3882
Ignition OFF, exterior lamps OFF, trunk latch latched, remove the E5AB
Tail/Stop Lamp - Right bulb.
Test for less than 5 ohms between the ground circuit at the socket
terminal and ground.
If 5 ohms or greater
Ignition OFF.
Test for less than 2 ohms in the ground circuit end to end.
© 2019-2025 Copyright www.chevtrax.com
