Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Place a suitable drain pan under the transfer case.
Fig. 2: Transfer Case Drain Plugs
NOTE: Both plu
Special Tools
J-41819 Input Shaft Seal Installer
DT-50937 Seal Protector
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right drive shaft. Refer to Front Whe
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement.
Remove the rear propeller sha
NOTE: The following steps must be completed before using the
symptom tables.
Perform the Diagnostic System Check - Vehicle before using the Symptom
Tables in order to verify that
all of the following are true:
There are no DTCs set.
The control modules can communicate via the serial data l
Replace the wheel if any of the following conditions exist:
The wheel exhibits excessive runout.
The wheel is bent.
The wheel is cracked.
The wheel is severely rusted.
The wheel is severely corroded.
NOTE: Air leaks caused by porosity on aluminum wheels are
repairable.
WARNING: If you are re