Chevrolet Trax: Intake manifold replacement
Chevrolet Trax (2013-2022) Workshop Manual / Engine / Engine Mechanical - 1.4L / Intake manifold replacement
READ NEXT:
Intake manifold replacement - Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and
Connection .
Remove the engine cover. Refer to Engine Cover Replacement.
Raise and support the vehicle.
Intake manifold replacement - Installation Procedure
Clean the sealing surfaces.
Fig. 38: Intake Manifold
Install the intake manifold (1) along with a NEW intake manifold gasket.
Fig. 39: Intake Manifold Bolts
CAUTION: Refer to Fastener Cautio
Camshaft intake and exhaust sprocket replacement
Special Tools
EN-955-A Locking Pin
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the air cleaner assembly. Refer to Air Cleaner Assembly
Replacement .
Remove the
SEE MORE:
Vibration analysis - engine/accessory isolation
Special Tools
CH-51450-NVH Oscilloscope Diagnostic Kit (w/NVH)
EL-38792-A Electronic Vibration Analyzer (EVA) 2
EL-38792-25 Inductive Pickup Timing Light
EL-47955 Multi Diagnostic Interface MDI
For equivalent regional tools, refer to Special Tools and Equipment.
Test Description
The numbers be
Transfer case fluid replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Place a suitable drain pan under the transfer case.
Fig. 2: Transfer Case Drain Plugs
NOTE: Both plugs are to be discarded if removed and NEW plugs
installed.
Remove the drain plug (2) and discard.
© 2019-2026 Copyright www.chevtrax.com
