Chevrolet Trax: Instrument Panel and Console Trim
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Instrument Panel and Console Trim
- Instrument Panel and Console Trim - Repair instructions
- Front floor console wiring harness replacement (encore)
READ NEXT:
Instrument Panel and Console Trim - Repair instructions
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
INSTRUMENT PANEL LOWER TRIM PANEL INSULATOR REPLACEMENT
Fig. 1: Instrument Panel Lower Trim
Instrument panel upper trim panel replacement (trax)
Removal Procedure
Remove the instrument panel assembly. Refer to Instrument Panel Assembly
Replacement (Trax).
Remove the windshield defroster outlet duct. Refer to Windshield
Defroster Outlet
Instrument panel upper trim panel replacement (encore)
Removal Procedure
Remove the instrument panel assembly. Refer to Instrument Panel Assembly
Replacement (Encore).
Remove the windshield defroster outlet duct. Refer to Windshield
Defroster Outle
SEE MORE:
DTC C0277 06, C0277 07, C0890 03, and C0890 07
Ignition OFF, disconnect the harness connector at the B22 Brake Pedal
Position Sensor, ignition ON.
Verify a test lamp illuminates between the appropriate low reference
circuit terminal listed below and B+.
Terminal 2 - with MH8/MHB
Terminal A - without MH8/MHB
If the test lamp does not
Parking brake rear cable replacement (disc brake) -
Removal Procedure
Removal Procedure
Remove the front floor console. Refer to Front Floor Console Replacement
(Encore) , Front Floor
Console Replacement (Trax) .
Ensure that the parking brake lever is in the fully released position.
Fig. 24: Front Cable Threaded Rod Nut
Using ONLY HAND TOOLS, loosen the adj
© 2019-2026 Copyright www.chevtrax.com
