Chevrolet Trax: Horns
- Schematic wiring diagrams
- Horns - Diagnostic information and procedures
- Horns - Repair instructions
- Horns - Description and operation
READ NEXT:
Schematic wiring diagrams
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
HORN WIRING SCHEMATICS (ENCORE)
Fig. 1: Horn (Encore)
HORN WIRING SCHEMATICS (TRAX)
H
DTC B2750: Horn relay secondary circuit
DIAGNOSTIC CODE INDEX
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diag
SEE MORE:
Vibration analysis - road testing (EL-38792-A ELECTRONIC VIBRATION ANALYZER)
Test Description
The numbers below refer to the step numbers on the diagnostic table.
5
Obtaining rotational speed for the components rotating at tire/wheel speed is
critical to systematically
eliminating specific vehicle component groups. These component rotational speeds
can be generated by
usin
StabiliTrak OFF Light
If equipped, this light comes on
briefly while starting the engine. If it
does not, have the vehicle serviced
by your dealer.
This light comes on when the
StabiliTrak system is turned off.
If StabiliTrak is off, the Traction
Control System (TCS) is also off.
If the TCS is off, the system does
not
© 2019-2026 Copyright www.chevtrax.com
