Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: Headlamp High/Low-Beam Changer

Headlamp High/Low-Beam Changer

(Headlamp High/Low-Beam Changer): Push the turn signal lever away from you and release, to turn the high beams on.

To return to low beams, push the lever again or pull it toward you and release.

This indicator light turns on in the instrument cluster when the high-beam headlamps are on.

Flash-to-Pass

To flash the high beams, pull the turn signal lever all the way toward you. Then release it.

Daytime Running Lamps (DRL)

If equipped with DRL, they make it easier for others to see the front of your vehicle during the day. Fully functional daytime running lamps are required on all vehicles first sold in Canada.

A light sensor on top of the instrument panel makes the DRL work, so be sure it is not covered.

The DRL system makes the low-beam headlamps come on at a reduced brightness when the following conditions are met:

  • The ignition is in the ON/ RUN mode.
  • The exterior lamp control is in AUTO.
  • The engine is running.

When the DRL are on, only the low-beam headlamps, at a reduced level of brightness, will be on. The taillamps, sidemarker, instrument panel, and other lamps will not be on.

The headlamps automatically change from DRL to the regular headlamps depending on the darkness of the surroundings. The other lamps that come on with the headlamps will also come on.

When it is bright enough outside, the headlamps go off and the DRL come on.

To turn the DRL off or on again, turn the exterior lamp control to the off position and then release. For vehicles first sold in Canada, the DRL cannot be turned off.

    READ NEXT:

     Automatic Headlamp System

    If equipped, the headlamps come on automatically when it is dark enough outside and the exterior lamp control is in the automatic position. See Exterior Lamp Controls The vehicle has a light sensor

     Turn and Lane-Change Signals

    Move the lever all the way up or down to signal a turn. An arrow on the instrument cluster will flash in the direction of the turn or lane change. Raise or lower the lever until the arrow starts t

     Interior Lighting

    Instrument Panel Illumination Control This feature controls the brightness of the instrument panel controls and infotainment display screen. The thumbwheel is to the left of the steering column on

    SEE MORE:

     DTC B2485: Wireless communication (BT) antenna

    Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provide an overview of each diagnostic category. DTC Descriptors DT

     Engine front cover with oil pump replacement

    Removal Procedure Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection . Set the engine to TDC. Refer to Camshaft Timing Chain Inspection. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the front wheelhouse li

    © 2019-2024 Copyright www.chevtrax.com