Chevrolet Trax: Engine replacement
READ NEXT:
Engine replacement - Removal Procedure
Remove the battery and battery tray. Refer to Battery Tray Replacement .
Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
Recover the refrigerant. Refer to Refrigerant Recovery an
Engine replacement - Installation Procedure
Install the transmission to the engine.
Fig. 165: Upper Transmission-To-Engine Bolts
CAUTION: Refer to Fastener Caution .
If equipped with a manual transmission, install the upper transmission
Engine oil and oil filter replacement
Removal Procedure
Open hood.
Place a drain pan below the vehicle.
CAUTION: To prevent damage to oil filter cap ensure proper tool is
used. Do not
use an open end wrench which may cause damage to
SEE MORE:
Parking brake rear cable replacement (disc brake) -
Removal Procedure
Removal Procedure
Remove the front floor console. Refer to Front Floor Console Replacement
(Encore) , Front Floor
Console Replacement (Trax) .
Ensure that the parking brake lever is in the fully released position.
Fig. 24: Front Cable Threaded Rod Nut
Using ONLY HAND TOOLS, loosen the adj
DTC B0163, B0183, OR B1405: Passenger compartment
temperature sensor/solar load sensor/control module voltage reference
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category.
DTC Descriptors
D
© 2019-2026 Copyright www.chevtrax.com
