Chevrolet Trax: Engine Heating and Cooling - Repair instructions
Chevrolet Trax (2013-2022) Workshop Manual / Engine / Engine Heating and Cooling / Engine Heating and Cooling - Repair instructions
- Cooling system draining and filling
- Coolant system flushing
- Turbocharger coolant return pipe replacement (LUJ)
- Engine coolant thermostat housing replacement (2H0, LDE)
- Engine coolant thermostat replacement (2H0, LDE, LFH)
- Engine coolant thermostat replacement (LUV, LUJ)
- Water outlet replacement (LUJ, LUV)
- Radiator replacement (LUJ, LUV)
READ NEXT:
Cooling system draining and filling
Draining Procedure
WARNING: To avoid being burned, do not remove the radiator cap or
surge tank
cap while the engine is hot. The cooling system will release scalding
fluid and steam under pressure if
Coolant system flushing
NOTE:
Do not use a chemical flush.
Store used coolant in the proper manner, such as in a used engine
coolant
holding tank.
Do not pour used coolant down a drain. Ethylene glycol antifreeze is
Turbocharger coolant return pipe replacement (LUJ)
Special Tools
EN-49940 Quick Connector Remover
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the turbocharger. Refer to Turbocharger Replacement
Fig. 38: Turboch
SEE MORE:
DTC B356A: Vehicle direction warning switch circuit
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior
to using this diagnostic procedure.
Review Strategy Based Diagnosis for an overview of
the diagnostic approach.
Diagnostic Procedure Instructions provides an
overview of each diagnostic category.
DTC Descriptors
D
Clutch pressure and driven plate replacement (1.6L AND
1.8L)
Special Tools
DT-6263 Remover/Installer Kit
DT-6263-32 Clutch Center Guide
EN-652 Flywheel Holder
For equivalent regional tools, refer to Special Tools.
Removal Procedure
NOTE:
To prevent damage to the spring fangs of pressure plate use the
DT-6263
remover/installer to remove and install
© 2019-2026 Copyright www.chevtrax.com
