Chevrolet Trax: DTC B3105: Keyless entry transmitters
Diagnostic Instructions
- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC B3105
Keyless Entry Transmitters
For symptom byte information, refer to Symptom Byte List .
Circuit/System Description
The body control module monitors the number of keyless entry transmitters programmed. Until at least one transmitter is programmed, the body control module determines a malfunction condition exists.
Conditions for Running the DTC
The body control module has been set up without transmitters being programmed.
Conditions for Setting the DTC
No keyless entry transmitter programmed to the body control module.
Action Taken When the DTC Sets
The keyless entry system is inoperative.
Conditions for Clearing the DTC
A current DTC is cleared when at least one transmitter has been programmed to the body control module.
Reference Information
Schematic Reference
Remote Function Schematics (Encore), Remote Function Schematics (Trax)
Connector End View Reference
WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INDEX - ENCORE WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INDEX - TRAX
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
- Circuit Testing
- Connector Repairs
- Testing for Intermittent Conditions and Poor Connections
- Wiring Repairs
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Verify that the transmitter is a correct transmitter for the vehicle. This can be accomplished by comparing the part number printed on the transmitter to the appropriate part number in the parts catalog.
- If the transmitter is incorrect
Replace the transmitter.
If the transmitter is correct
- Program the transmitter. Refer to Key with Integrated Transmitter Programming .
- Verify the transmitter has successfully completed the programming procedure.
If the transmitter does not program successfully
Replace the transmitter.
If the transmitter programs successfully
- All OK.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the repair.
Key with Integrated Transmitter Programming
READ NEXT:
DTC B3106: Keyless entry data link
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B3109-B3113: Keyless entry transmitter 1-5 battery
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B310D-B310F: Keyless entry transmitter 6-8 battery
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Rear wheel speed sensor replacement
Removal Procedure
WARNING: Refer to Brake Dust Warning .
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation .
Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner
R
Starting the Engine
Place the transmission in the
proper gear.
Caution
If you add electrical parts or
accessories, you could change
the way the engine operates. Any
resulting damage would not be
covered by the vehicle warranty.
Caution
If the steering wheel is turned
until it reaches the end of its
travel, and is held
