Chevrolet Trax: Remote Functions - Diagnostic information and procedures
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Remote Functions / Remote Functions - Diagnostic information and procedures
SCHEMATIC WIRING DIAGRAMS
REMOTE FUNCTION WIRING SCHEMATICS (ENCORE)
Keyless Entry System
Fig. 1: Keyless Entry System (Encore)
REMOTE FUNCTION WIRING SCHEMATICS (TRAX)
Keyless Entry System
.gif)
Fig. 1: Keyless Entry System (Encore)
REMOTE FUNCTION WIRING SCHEMATICS (TRAX)
Keyless Entry System
.gif)
Fig. 2: Keyless Entry System (Trax)
DIAGNOSTIC INFORMATION AND PROCEDURES
DIAGNOSTIC CODE INDEX
.jpg)
- DTC B3101: Keyless entry data link circuit
- DTC B3105: Keyless entry transmitters
- DTC B3106: Keyless entry data link
- DTC B3109-B3113: Keyless entry transmitter 1-5 battery
- DTC B310D-B310F: Keyless entry transmitter 6-8 battery
- Remote vehicle start malfunction
READ NEXT:
DTC B3101: Keyless entry data link circuit
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagn
DTC B3105: Keyless entry transmitters
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B3106: Keyless entry data link
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
DTC B3950 OR B3951
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach
Diagnostic Procedure Instructions provides an overview of each diagnostic
category.
DTC Descriptors
DTC
DTC B3951
Ignition OFF, disconnect the X5 harness connector at the K9 Body Control
Module, ignition ON.
Verify a test lamp illuminates between the B+ circuit terminal 3 and
ground.
If the test lamp does not illuminate and the circuit fuse is good
Ignition OFF.
Test for less than 2 ohms in the B+
© 2019-2026 Copyright www.chevtrax.com
