Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: Specifications

Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Collision Repair / Specifications

DIMENSIONS - BODY (ENCORE)

Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths. All die marks, holes, slots, and fasteners are measured to the center. All dimensions are symmetrical unless otherwise specified.

Point-to-Point Measurements

Front End

Fig. 1: Front End Point-to-Point Measurements
Fig. 1: Front End Point-to-Point Measurements

Engine Compartment

Fig. 2: Engine Compartment Point-to-Point Measurements
Fig. 2: Engine Compartment Point-to-Point Measurements

Front End Lower

Fig. 3: Front End Lower Point-to-Point Measurements
Fig. 3: Front End Lower Point-to-Point Measurements

Rear End Lower

Fig. 4: Rear End Lower Point-to-Point Measurements
Fig. 4: Rear End Lower Point-to-Point Measurements

Rear End

Fig. 5: Rear End Point-To-Point Measurements
Fig. 5: Rear End Point-To-Point Measurements

Side

Fig. 6: Side Point-To-Point Measurements
Fig. 6: Side Point-To-Point Measurements

DIMENSIONS - BODY (TRAX)

Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths. All die marks, holes, slots, and fasteners are measured to the center. All dimensions are symmetrical unless otherwise specified.

Point-to-Point Measurements

Front End

Fig. 7: Front End Point-to-Point Measurements
Fig. 7: Front End Point-to-Point Measurements

Engine Compartment

Fig. 8: Engine Compartment Point-to-Point Measurements
Fig. 8: Engine Compartment Point-to-Point Measurements

Front End Lower

Fig. 9: Front End Lower Point-to-Point Measurements
Fig. 9: Front End Lower Point-to-Point Measurements

Rear End Lower

Fig. 10: Rear End Lower Point-to-Point Measurements
Fig. 10: Rear End Lower Point-to-Point Measurements

Rear End

Fig. 11: Rear End Point-to-Point Measurements
Fig. 11: Rear End Point-to-Point Measurements

Side

Fig. 12: Side Point-to-Point Measurements
Fig. 12: Side Point-to-Point Measurements

    READ NEXT:

     Collision Repair - Visual identification

    STRUCTURE IDENTIFICATION Fig. 13: Front Structure View Front Fig. 14: Rear Structure View Rear

     Collision repair - Repair instructions

     Front wheelhouse panel replacement

    Removal Procedure Disable the SIR system. Refer to SIR Disabling and Enabling . Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection NOTE: Section

    SEE MORE:

     Engine Exhaust

    Warning Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death. Exhaust may enter the vehicle if: The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody airfl

     Intake manifold replacement - Installation Procedure

    Clean the sealing surfaces. Fig. 38: Intake Manifold Install the intake manifold (1) along with a NEW intake manifold gasket. Fig. 39: Intake Manifold Bolts CAUTION: Refer to Fastener Caution . Install the 6 intake manifold bolts (1) and tighten to 20 (15 lb ft). Fig. 40: Fuel Feed Pi

    © 2019-2026 Copyright www.chevtrax.com