Chevrolet Trax: Filling a Portable Fuel Container
Warning
Filling a portable fuel container while it is in the vehicle can cause fuel vapors that can ignite either by static electricity or other means. You or others could be badly burned and the vehicle could be damaged. Always:
- Use approved fuel containers.
- Remove the container from the vehicle, trunk, or pickup bed before filling.
- Place the container on the ground.
- Place the nozzle inside the fill opening of the container before dispensing fuel, and keep it in contact with the fill opening until filling is complete.
- Fill the container no more than 95% full to allow for expansion.
- Do not smoke, light matches, or use lighters while pumping fuel.
- Avoid using cell phones or other electronic devices.
Towing
General Towing Information
The vehicle is neither designed nor intended to tow a trailer.
Conversions and Add-Ons
Add-On Electrical Equipment
Caution
Some electrical equipment can damage the vehicle or cause components to not work and would not be covered by the warranty. Always check with your dealer before adding electrical equipment.
Add-on equipment can drain the vehicle's 12-volt battery, even if the vehicle is not operating.
The vehicle has an airbag system.
Before attempting to add anything electrical to the vehicle, see Servicing the Airbag-Equipped Vehicle and Adding Equipment to the Airbag-Equipped Vehicle
READ NEXT:
General Information
For service and parts needs, visit
your dealer. You will receive
genuine GM parts and GM-trained
and supported service people.
Genuine GM parts have one of
these marks:
California Proposition
65 Wa
SEE MORE:
Turbocharger removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Fig. 261: Holding Wrench And Ratchet Wrench
Install the EN-49942 holding wrench (2) to the turbocharger coolant feed
pipe. Guide a ratchet wrench
(1) along with an extension through EN-49942 holding wr
Instrument panel assembly replacement (trax)
Removal Procedure
Disable the SIR system. Refer to SIR Disabling and Enabling .
Fig. 30: Windshield Garnish Molding Assembly
Remove both of the windshield garnish moldings (1). Refer to Windshield
Garnish Molding
Replacement (Trax) .
Fig. 31: Front Floor Console
Remove the front floor
