Cylinder Block
The cylinder hollow frame structured in-line 4 cylinder. The block has 5
crankshaft bearings with the thrust
bearing located on the third bearing from the front of the engine.
Cranksha
An automobile engine is a combination of many of the following surfaces:
Machined
Honed
Polished
Lapped
The tolerances of these surfaces are measured in the ten-thousandths of an
inch. When you
DIAGNOSTIC INFORMATION AND PROCEDURES
SQUEAKS AND RATTLES
NOTE: Squeaks and rattles are caused by improperly controlled
relative motion
between vehicle components. There are 4 ways to prevent squeaks and
rattles.
Attach the component that squeaks or rattles securely.
Separate the components that
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category
Diagnostic Fault I