Chevrolet Trax: Compact Spare Tire
Warning
Driving with more than one compact spare tire at a time could result in loss of braking and handling. This could lead to a crash and you or others could be injured. Use only one compact spare tire at a time.
If this vehicle has a compact spare tire, it was fully inflated when new; however, it can lose air over time.
Check the inflation pressure regularly. It should be 420 kPa (60 psi).
Stop as soon as possible and check that the spare tire is correctly inflated after being installed on the vehicle. The compact spare tire is designed for temporary use only.
The vehicle will perform differently with the spare tire installed and it is recommended that the vehicle speed be limited to 80 km/h (50 mph). To conserve the tread of the spare tire, have the standard tire repaired or replaced as soon as convenient and return the spare tire to the storage area.
When using a compact spare tire, the ABS and Traction Control systems may engage until the spare tire is recognized by the vehicle, especially on slippery roads. Adjust driving to reduce possible wheel slip.
Caution
When the compact spare is installed, do not take the vehicle through an automatic car wash with guide rails. The compact spare can get caught on the rails which can damage the tire, wheel, and other parts of the vehicle.
Do not use the compact spare on other vehicles.
Do not mix the compact spare tire or wheel with other wheels or tires.
They will not fit. Keep the spare tire and its wheel together.
Caution
Tire chains will not fit the compact spare. Using them can damage the vehicle and the chains. Do not use tire chains on the compact spare.
READ NEXT:
Full-Size Spare Tire
If this vehicle came with a full-size
spare tire, it was fully inflated when
new, however, it can lose air over
time. Check the inflation pressure
regularly. See Tire Pressure and Vehicle Load Limits
Jump Starting
For more information about the
vehicle battery, see Battery
If the battery has run down, try to
use another vehicle and some
jumper cables to start your vehicle.
Be sure to use the following steps to
SEE MORE:
Actuator recalibration
HVAC Control Module Replacement
When replacing or disconnecting the HVAC control module, it will be necessary
to perform a recalibration
process. When installing or reconnecting the HVAC control module, be sure to
perform the following:
Preferred Method (with Scan Tool)
NOTE: Do not adjust any con
Hood rear weatherstrip replacement (encore)
Fig. 41: Hood Rear Weatherstrip
Hood Rear Weatherstrip Replacement (Encore)
LIFTGATE STRUT REPLACEMENT
Fig. 42: Liftgate Strut
Liftgate Strut Replacement
FRONT OR REAR SIDE DOOR LOWER WEATHERSTRIP REPLACEMENT
Fig. 43: Side Door Lower Weatherstrip
Front or Rear Side Door Lower Weatherstri
