Chevrolet Trax: Windshield Wiper/Washer
.gif)
The windshield wiper/washer lever is on the right side of the steering column.
Move the lever to one of the following positions: HI: Use for fast wipes.
LO: Use for slow wipes.
.gif)
INT (Intermittent Wipes): Move
the lever up to INT for intermittent
wipes, then turn the .gif)
INT band
up for more frequent wipes or down
for less frequent wipes.
OFF: Use to turn the wipers off.
1X (Mist): For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down.
.gif)
(Windshield Washer): Pull the
windshield wiper lever toward you to
spray windshield washer fluid and
activate the wipers. The wipers will
continue until the lever is released
or the maximum wash time is
reached. When the windshield wiper
lever is released, additional wipes
may occur depending on how long
the windshield washer had been
activated. See Washer Fluid for information on filling
the windshield washer fluid
reservoir.
Warning
In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision.
Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. See Wiper Blade Replacement
Heavy snow or ice can overload the wiper motor. A circuit breaker will stop the motor until it cools down.
READ NEXT:
Rear Window Wiper/ Washer
The rear wiper/washer controls are
on the end of the windshield wiper
lever.
ON: Press the upper portion of the
button for continuous rear window
wipes.
OFF: The rear wiper turns off when
the butto
Compass
The vehicle may have a compass
display in the Driver Information
Center (DIC).
Setting the Compass Zone
Under certain circumstances, such
as during a long trip or moving to a
new area, the compass zon
Clock
Radio without Touchscreen
The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation
for information about how to use the
menu system.
Setti
SEE MORE:
Transmission adaptive values learn
Transmission Adaptive Values Learn is a procedure for 6 speed automatic
transmissions in which a series of
tests are run to allow the transmission control module (TCM) to learn individual
clutch characteristics. Once the
clutch data is learned, Transmission Adaptive Values Learn translates it into
Front wheel drive shaft outer joint and boot replacement
Special Tools
DT-35910 Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools
Disassemble Procedure
Remove the wheel drive shaft from the vehicle. Refer to Front Wheel
Drive Shaft Replacement - Left
Side, and Front Wheel Drive Shaft Replacement - Right Side.
Fig.
