Chevrolet Trax: Seat Heating and Cooling - Diagnostic information and procedures
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Seat Heating and Cooling / Seat Heating and Cooling - Diagnostic information and procedures
- DTC B1925 OR B2170 (without memory A45): Seat cushion heater sensor
- DTC B1925 OR B2170 (With memory A45): Seat cushion heater sensor
- DTC B2345 (WITHOUT MEMORY A45): Seat heater disable circuit low voltage/high temperature
- DTC B2345 (WITH MEMORY A45): Seat heater disable circuit low voltage high/temperature
- DTC B2425 OR B2430 (WITHOUT MEMORY A45): Seat cushion heater circuit
- DTC B2425 OR B2430 (WITH MEMORY A45): Seat cushion heater circuit
- DTC B242A (WITHOUT MEMORY A45): Seat heaters common circuit
- DTC B242A (WITH MEMORY A45): Seat heaters common circuit
- Front heated seat malfunction (without memory A45)
- Front heated seat malfunction (with memory A45)
READ NEXT:
DTC B1925 OR B2170 (without memory A45): Seat cushion heater sensor
SCHEMATIC WIRING DIAGRAMS
HEATED/COOLED SEAT WIRING SCHEMATICS (ENCORE)
KA1
Fig. 1: KA1
HEATED/COOLED SEAT WIRING SCHEMATICS (TRAX)
KA1
Fig. 2: KA1
DIAGNOSTIC INFORMATION AND PROCEDURES
DTC B1925
DTC B1925 OR B2170 (With memory A45): Seat cushion heater sensor
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
DTC B2345 (WITHOUT MEMORY A45): Seat heater disable circuit low voltage/high
temperature
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diag
SEE MORE:
Schematic wiring diagrams
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
POWER STEERING PUMP SPECIFICATIONS
Power Steering Pump Specifications
ADHESIVES, FLUIDS, LUBRICANTS, AND SEALERS
Adhesives, Fluids, Lubricants, and Sealers
SCHEMATIC WIRING DIAGRAMS
POWER STEERING WIRING SCH
DTC C0277 06, C0277 07, C0890 03, and C0890 07
Ignition OFF, disconnect the harness connector at the B22 Brake Pedal
Position Sensor, ignition ON.
Verify a test lamp illuminates between the appropriate low reference
circuit terminal listed below and B+.
Terminal 2 - with MH8/MHB
Terminal A - without MH8/MHB
If the test lamp does not
© 2019-2026 Copyright www.chevtrax.com
