Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: Repair instructions

READ NEXT:

 Rear wheel drive module differential clutch control module replacement

Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . NOTE: The propeller shaft does not have to be removed from this vehicle to replace rear differential m

 Rear axle shaft replacement

Special Tools J-2619-01 Slide Hammer J-45019 Flange Remover For equivalent regional tools, refer to Special Tools . Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking

 Differential carrier assembly replacement

Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Drain the rear differential carrier. Refer to Differential Oil Replacement . Disconnect the propelle

SEE MORE:

 Cylinder head replacement - Installation Procedure

For assembly of the cylinder head. Refer to Cylinder Head Assemble. CAUTION: Refer to Fastener Caution . Install the cylinder head assembly parts: Install the 3 engine lift bracket bolts and tighten to 22 (16 lb ft). Install the timing chain tensioner. Refer to Timing Chain Tensioner Inst

 DTC P0300-P0304

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptors D

© 2019-2026 Copyright www.chevtrax.com