Chevrolet Trax: New product information

Chevrolet Trax (2013-2022) Workshop Manual / Transmission / Transfer Case - AAM / Description and operation / New product information

Interim Model Year Design Changes

The purpose of New Product Information is to document, important product changes which occur either model year-to-model year or interim model year.

Changes may include one or more of the following items:

Specification Changes
New sealants and/or adhesives
Disassembly and assembly procedure revisions
Mechanical and diagnostic procedure revisions
New special tools required
Interim Model Year Design Changes
A component comparison from the previous model year

SPECIAL TOOLS AND EQUIPMENT

SPECIAL TOOLS

SPECIAL TOOLS AND EQUIPMENT

SEE MORE:

Catalytic converter movement caution

CAUTION: To prevent internal damage to the flexible coupling of the catalytic converter assembly, the converter must be supported. The vertical movement at the rear of the catalytic converter assembly must not exceed 6 degrees up or down. CLEAN, DRY, LOW PRESSURE GAS SOURCE CAUTION CAUTION: Use the

Strut assembly removal and installation

Special Tools CH-49375 Spanner For equivalent regional tools, refer to Special Tools . Removal Procedure Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Trax) , Air Inlet Grille Panel Replacement (Encore) . Fig. 32: Front Suspension Strut Mount Plate Nut Cap

Chevrolet Trax: New product information

READ NEXT:

Transmission Cooling

Diagnostic information and procedures

Repair instructions

SEE MORE:

Catalytic converter movement caution

Strut assembly removal and installation