Chevrolet Trax: General Information
Chevrolet Trax (2013-2022) Workshop Manual / General Information & Maintenance / General Information
- General Information - Encore And Trax
- Fasteners
- Front side door lock cylinder coding (free wheeling)
- Lock cylinder coding - ignition
- Lifting and jacking the vehicle
READ NEXT:
General Information - Encore And Trax
INTRODUCTION
ARROWS AND SYMBOLS
This service manual uses various symbols in order to describe different
service operations.
Fig. 1: Identifying Different Service Operations Symbols
ACRONYMS AND U
Fasteners
Metric Fasteners
This vehicle provides fastener dimensions using the metric system. Most
metric fasteners are approximate in
diameter to equivalent English fasteners. Make replacements using fastener
Front side door lock cylinder coding (free wheeling)
Special Tools
BO-49753 Assembly Tool
Fig. 9: Identifying Lock Components
The door lock cylinder uses 8 of the 8 cut positions. The tumbler positions
are staggered from side to side, 4 on one side a
SEE MORE:
Description and operation
CLUTCH SYSTEM DESCRIPTION AND OPERATION
Clutch Spin Down Time
Inspect the clutch spin down time as follows:
Apply the parking brake and block the vehicle wheels.
Shift the manual transmission into NEUTRAL.
Start the engine. Run the engine at idle speed.
Engage the clutch.
Disengage the clutch.
Repair instructions
TIRE AND WHEEL ASSEMBLY BALANCING - OFF VEHICLE
WARNING: Failure to adhere to the following precautions before tire
balancing can
result in personal injury or damage to components:
Clean away any dirt or deposits from the inside of the wheels.
Remove any stones from the tread.
Wear eye protecti
© 2019-2026 Copyright www.chevtrax.com
