Chevrolet Trax: Description and operation
Chevrolet Trax (2013-2022) Workshop Manual / Accessories & Equipment / Collision Repair / Description and operation
READ NEXT:
Dual phase steel
This information provides repair recommendations and general guidelines for
steel classified as Dual Phase
Steel (dual phase steel with a tensile strength up to and including 800 MPa),
also known as
Ultra high strength dual phase steel
This information provides repair recommendations and general guidelines for
steel classified as Ultra High
Strength Dual Phase Steel (dual phase steel with a tensile strength greater than
800 MPa),
Cabin Air Filter
REMOVAL & INSTALLATION
NOTE: Manufacturer's terminology for this filter is passenger
compartment air filter.
CABIN AIR FILTER
Removal & Installation
Fig. 1: Passenger Compartment Air Filter
SEE MORE:
Wheel drive shaft outer joint inspection
Disassembly Procedure
Remove the outer constant velocity (CV) joint and boot from the wheel
drive shaft. Refer to Front Wheel
Drive Shaft Outer Joint and Boot Replacement.
Remove any lubricant from the CV joint.
Fig. 64: Taping Gently On Brass Drift With A Hammer In Order To Tilt Cage
NOTE:
Side object sensor programming and setup
NOTE:
DO NOT program a side object sensor - left unless directed to by a
service
procedure or a service bulletin. If the side object sensor - left is not
properly configured with the correct calibration software, the side object
sensor - left will not control all of the vehicle features prope
© 2019-2025 Copyright www.chevtrax.com
