Chevrolet Trax: Cylinder head replacement
Chevrolet Trax (2013-2022) Workshop Manual / Engine / Engine Mechanical - 1.4L / Cylinder head replacement
READ NEXT:
Cylinder head replacement - Removal Procedure
Special Tools
EN-470-B Angular Torque Wrench
EN-955 Fixing Pin
EN-953-A Fixing Tool
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Disconnect battery negative cable. R
Cylinder head replacement - Installation Procedure
For assembly of the cylinder head. Refer to Cylinder Head Assemble.
CAUTION: Refer to Fastener Caution .
Install the cylinder head assembly parts:
Install the 3 engine lift bracket bolts and t
Oil pan replacement
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner
Replacement (
SEE MORE:
Rear differential clutch control module programming and setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
NOTE:
DO NOT program a control module unless directed to by a service
procedure or a service bulletin. If the ECU is not properly configured with
the correct calibration software, the ECU w
Side object sensor programming and setup
NOTE:
DO NOT program a side object sensor - left unless directed to by a
service
procedure or a service bulletin. If the side object sensor - left is not
properly configured with the correct calibration software, the side object
sensor - left will not control all of the vehicle features prope
© 2019-2026 Copyright www.chevtrax.com
