Chevrolet Trax: Vibration Diagnosis and Correction
Chevrolet Trax (2013-2022) Workshop Manual / General Information & Maintenance / Vibration Diagnosis and Correction
- Diagnostic information and procedures
- Vibration analysis - road testing (EL-38792-A ELECTRONIC VIBRATION ANALYZER)
- Vibration analysis - hub and/or axle input
- Vibration analysis - engine/accessory isolation
- Vibration diagnostic aids
- Brake rotor/drum balance inspection
- Repair instructions
- Description and operation
READ NEXT:
Diagnostic information and procedures
SPECIFICATIONS
TIRE AND WHEEL RUNOUT SPECIFICATIONS
Tire and Wheel Runout Specifications
DIAGNOSTIC INFORMATION AND PROCEDURES
VIBRATION DIAGNOSIS, STARTING POINT, AND CORRECTION
The information con
Vibration analysis - road testing (EL-38792-A ELECTRONIC VIBRATION ANALYZER)
Test Description
The numbers below refer to the step numbers on the diagnostic table.
5
Obtaining rotational speed for the components rotating at tire/wheel speed is
critical to systematically
elimin
Vibration analysis - hub and/or axle input
Test Description
The numbers below refer to the step numbers on the diagnostic table:
2
This test will determine the effect of turning input on the vibration.
6
This test will determine the effect of
SEE MORE:
Schematic wiring diagrams
SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
SIR WIRING SCHEMATICS (ENCORE)
Power, Ground, Passenger Presence, Serial Data and Indicators
Fig. 1: Power, Ground, Passenger Presence, Serial Data and Indicators
Front Air Bags, and Impact Sensors (AY0 or AYF)
Fig. 2:
Safety Belt Reminders
Driver Safety Belt Reminder
Light
There is a driver safety belt
reminder light on the instrument
cluster.
When the vehicle is started, this
light flashes and a chime may come
on to remind the driver to fasten
their safety belt. Then the light stays
on solid until the belt is buckled.
This cycle may
© 2019-2026 Copyright www.chevtrax.com
