Chevrolet Trax: Vehicle Messages
DIC messages display when the status of the vehicle has changed and action may be needed to correct the condition. Multiple messages appear one after another.
Press any of the DIC buttons on the turn signal lever to acknowledge and clear them from the display.
More urgent messages cannot be cleared from the DIC display. All messages should be taken seriously. Clearing messages will not correct the problem.
Vehicle messages appear as code numbers.
25: Left Front Turn Indicator Failure
26: Left Rear Turn Indicator Failure
27: Right Front Turn Indicator Failure
28: Right Rear Turn Indicator Failure
73: Service All Wheel Drive System
84: Engine Power Is Reduced
89: Service Vehicle Soon
125: Compass Calibrating - Drive in Circles
173: All Wheel Drive Off
Engine Oil Messages
.gif)
% CHANGE
This message displays when the engine oil needs to be changed.
When changing the engine oil, be sure to reset the Oil Life System.
See Engine Oil Life System, Engine Oil and Maintenance Schedule
Tire Messages
LF XX, RF XX, LR XX, or RR XX
A message displays when the tire pressure is low. It shows the location of the low tire and the approximate pressure of the low tire.
If a tire pressure message appears, stop as soon as you can. Inflate the tires by adding air until the tire pressure is equal to the values shown on the Tire and Loading Information label. See Tires, Vehicle Load Limits and Tire Pressure
READ NEXT:
Trip Computer
The trip computer is located in the
Driver Information Center (DIC).
It provides the driver with driving
information such as average speed,
fuel range, average fuel economy,
and a timer.
SET/CLR:
Personalization Menu (Radio
without Touchscreen)
The audio system controls and
touchscreen are used to access the
personalization menus for
customizing vehicle features.
The following are all possible
personalization features. Depending
on the vehi
SEE MORE:
Front view camera module programming and setup
Front View Camera Module Replacement
If the Front View Camera Module needs to be replaced, the following
procedures must be performed:
Connect a scan tool to the vehicle and access Service Programming System
(SPS).
Perform the SPS function Front View Camera Module - Programming and
follow th
Neutral - Engine Running - Gen 2/Hybrid
Fig. 8: Neutral -- Engine Running Fluid Flow Diagram
Drive Range, First Gear Engine Braking (Gen 2/Hybrid)
Note: Some models of the 6T30/40/45/50 automatic transmission are equipped
with an electric auxiliary fluid
pump for use in hybrid vehicles (BAS+). Hybrid vehicles do not require internal
c
