Chevrolet Trax Owners & Service Manuals

Chevrolet Trax: Programming and Setup - All ASystems

Diagnostic information and procedures

CONTROL MODULE REFERENCES

Reference Information

  • Data Link References
  • Diagnostic System Check - Vehicle
  • Diagnostic Trouble Code (DTC) List - Vehicle
  • Symptoms - Vehicle

Control Module References

Control Module References

Control Module References

Control Module References

Control Module References

READ NEXT:

 Repair instructions

AUDIO AMPLIFIER PROGRAMMING AND SETUP Replace and Program Control Module or Reprogram Control Module This control module does not require SPS programming or any setup procedures. BODY CONTROL MODULE P

 Chassis control module programming and setup

NOTE: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the

 Electronic brake control module programming and setup

NOTE: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the c

SEE MORE:

 Low and reverse and 1-2-3-4 clutch housing isassemble

Low and Reverse Clutch Piston Removal Fig. 39: View Of Low & Reverse Clutch Piston Low and Reverse Clutch Piston Removal 1-2-3-4 Clutch Piston Removal Fig. 40: View Of 1-2-3-4 Clutch Piston 1-2-3-4 Clutch Piston Removal LOW AND REVERSE AND 1-2-3-4 CLUTCH HOUSING CLEANING AND INSPECTION

 Dolly Towing (Front-Wheel-Drive Vehicles Only)

To tow a front-wheel-drive vehicle from the front with two wheels on the ground: Put the front wheels on a dolly. Move the shift lever to P (Park). Set the parking brake. Clamp the steering wheel in a straight-ahead position with a clamping device designed for towing. Remove the key from

© 2019-2025 Copyright www.chevtrax.com