Special Tools
BO-24402-A Glass Sealant Remover (Cold Knife)
BO-39032 Stationary Glass Removal Tool
Use an adhesive that is approved by GM
For equivalent regional tools, refer to Special Tools.
Re
Special Tools
J 24402-A Glass Sealant (Cold Knife) Remover
J 39032 Stationary Glass Removal Tool
Use a urethane adhesive systems which meet GM Specification GMW 15672
Removal Procedure
WARNING: R
Window Motor Normalized Procedure
A window motor that has not been normalized will no longer perform the
express up and express down
functions, this may occur during the following conditions:
When
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic
approach.
Diagnostic Procedure Instructions provides an overview of each
diagnostic category
DTC Descriptors
DT
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Place a suitable drain pan under the transfer case.
Fig. 2: Transfer Case Drain Plugs
NOTE: Both plugs are to be discarded if removed and NEW plugs
installed.
Remove the drain plug (2) and discard.